Spring Cone Crusher

Spring Cone Crusher breaks material by squeezing or compressing it between convex and concave shaped surfaces covered by manganese as the wear surface. Normally used as the secondary or tertiary crusher, the cone crusher has been developed to crush high or medium hardness material, such as iron ore ,copper ore, limestone, quartz, granite, and sand stones, etc.

The spring cone crusher has been developed to crush feed materials into desired end products efficiently, reliably and economically.This series offers the highest crushing efficiency and end product quality with the lowest cost per tone production.

The safety system uses dry oil and water as two kinds of sealed formation to make plaster powder and engine oil separate to make sure reliable performance. The type of crushing chamber depends upon size of feeding and fineness of crushed product. The standard type (PYB) is applied to medium crushing, the medium type is applied to medium or fine crushing and the short head type is applied to fine crushing.

Features:

1. The spring cone crushers crushes by the change of the gap in the crushing cavity;

2. High reduction ratio, high performance, low power consumption, and uniform size products.

Specifications:

Type Max. input (mm) Adjusting range of output (mm) Capacity (t/h) Motor power (kW) weight (t) Overall dimensions (L×W×H)(mm)
PYB 600 65 12-25 12-25 30 5 2800×1300×1700
PYD 35 3-15 5-23 5.5
PYB 900 115 15-50 50-90 55 10.2 3050×1640×2350
PYZ 60 5-20 20-65 10.2
PYD 40 3-13 15-50 10.3
PYB 1200 145 20-50 110-200 110 24.7 4152×2300×2980
PYZ 100 8-26 50-150 25
PYD 50 3-15 18-105 25.6
PYB 1750 215 25-60 280-480 160 50.3 4870×3800×4192
PYZ 185 10-30 115-320 50.3
PYD 85 5-15 75-230 50.4
PYB 2200 300 30-60 590-1000 260-280 80 7705×3430×4852
PYZ 230 10-30 200-580 80
PYD 100 5-15 120-340 81.4

Note:Any change of technical data shall not be advised additionally.